stm32f4xx_hal_conf_template.h File Reference

HAL configuration template file. This file should be copied to the application folder and renamed to stm32f4xx_hal_conf.h. More...

Go to the source code of this file.

Variables
	C

Detailed Description

HAL configuration template file. This file should be copied to the application folder and renamed to stm32f4xx_hal_conf.h.

Author

MCD Application Team

Attention

Copyright (c) 2017 STMicroelectronics. All rights reserved.

This software is licensed under terms that can be found in the LICENSE file in the root directory of this software component. If no LICENSE file comes with this software, it is provided AS-IS.

Definition in file stm32f4xx_hal_conf_template.h.

Variable Documentation

C

C

extern

Value of the External oscillator in Hz Time out for HSE start up, in ms Value of the Internal oscillator in Hz LSI Typical Value in Hz Value of the Internal Low Speed oscillator in Hz The real value may vary depending on the variations in voltage and temperature. Value of the External Low Speed oscillator in Hz Time out for LSE start up, in ms Value of the External oscillator in Hz Value of VDD in mv tick interrupt priority Transceiver Basic Control Register
Transceiver Basic Status Register
PHY Reset Select loop-back mode Set the full-duplex mode at 100 Mb/s Set the half-duplex mode at 100 Mb/s Set the full-duplex mode at 10 Mb/s
Set the half-duplex mode at 10 Mb/s
Enable auto-negotiation function
Restart auto-negotiation function
Select the power down mode
Isolate PHY from MII
Auto-Negotiation process completed
Valid link established
Jabber condition detected
PHY status register Offset
MII Interrupt Control Register
MII Interrupt Status and Misc. Control Register PHY Link mask
PHY Speed mask
PHY Duplex mask
PHY Enable interrupts
PHY Enable output interrupt events
Enable Interrupt on change of link status
PHY link status interrupt mask